Mock Plumbing Fabrication Shop

Fabrication Shop

Sheet Metal Fabrication Shop
For many years in our industry, portions of our work involving sheet metal fabrication were typically subcontracted out by mechanical contractors. Indeed, many mechanical contractors continue this practice or use "sister" contractors for their sheet metal fabrication and installation needs. Not so with Mock Plumbing & Mechanical, Inc.

As ceiling spaces or mechanical equipment rooms get smaller, the necessity of job-site coordination becomes greater. And, because the interaction between piping and ductwork can dictate the progress of the mechanical system installation (and, thus, the entire project), Mock recognizes the importance of using our "in-house" sheet metal fabrication facility and installers to fully integrate the sheet metal work with other portions of mechanical work.

The ability to schedule, monitor, and quality check each piece of sheet metal product shipped to the project is an added benefit to our customers.

Production Capabilities

Mock Plumbing & Mechanical, Inc., can produce your most intricate sheet metal needs. We regularly stock galvanized sheet metal from 26 gauge to 16 gauge, black iron sheet metal in various gauges, and stainless steel sheet metal in various gauges, finishes, and degrees of hardness.

We specialize in the mass quantity production of galvanized sheet metal ductwork built to the latest SMACNA and ASHRAE standards.

We have the production equipment to cut, bend, roll, and form metal to 16 gauge.

Mock utilizes an automated insulation/welding system to produce internally insulated ductwork and fittings. We stock duct liner in thicknesses of 1" and 1/2" of varying densities. Our equipment can install liner up to 2" thick.

Our latest addition is a vicon plasma-cutting table, which has greatly increased our production.

We are continually updating our facilities with the latest state of the art equipment.